How to fix a seat belt buckle

How to fix a seat belt buckle

There are instances when somebody goes to buckle his seatbelt, but find it hard to fasten up properly. Others find the buckle clip jammed or even thrashed. Here is “Howto fix a seat belt buckle”.

It is a popular question among drivers. Sometimes they have to deal with that annoying seatbelt warning as well. This all can be easily fixed up by self without getting assistance of an auto mechanic. You only need a new buckle, some tools and with no doubt a little bit of patience if you want the comfort of the driver’s seat back!

There are different problems, minute and large discussed here to get the answer of how to fix a seat belt buckle.

1.       Jamming of Buckle:

People often come up with the problem of seat belt buckle jamming. Buckle gets locked without belt inserted. It prevents insertion of the belt part in it. That time you can make use of a simple trick. With the help of a long but slender thing like a plastic ruler you can unlock buckle. Just slide it in and out or by sides into the buckle’s slot usually where the belt end is inserted. The lock will open.

2.      Wear and tear of seat belt buckle:

With long time use, the plastic of belt buckle wears out. This gives birth to the problem of its latching. At this point of time, you have only a single choice to replace the entire seat belt assembly or only the buckle with a new one.

For this, you can contact your car dealer. If not available, you can call up several junk yards to get the matching piece. The steps for replacing the buckle are explained here below:

·         At the beginning, purchase a similar seat belt buckle or arrange it from the local junkyard.

You can also look for a universal buckle, if physical appearance doesn’t bother you. Many online stores have come up to offer such spares at reasonable cost, thus; it can also be looked upon.

·         Then, look for the mounting of the buckle. Most automobiles have it bolted to its base. In other cases, the seat has to be removed or shifted in locating the foundation of the buckle. Just follow the seat belt strap to end. You will find it by some efforts.

·         With the help of suitable tools, remove any decorative accessory on the floor, which is covering the buckle base.

·         Next, make use of a wrench and turn mounting bolts of buckle one by one in counter clockwise direction. Remove the crappy buckle out of there.

·         After adjusting the new buckle and fitting it to the lining, snug the bolt suitably by rotating wrench clockwise this time.

·         Finally, test the buckle by buckling seatbelt, many a times. Ensure all bolts are in their place.